VCV Rack 2 – Cosmic Core Synth 2d – Ping Pong Patch

Modules used in the Cosmic Core Synth 2d – Ping Pong patch…

Brand	Module	Function
VCV	8VERT	Used to Send a Signal and an Inverted Signal
VCV	VCO	Accepts musical notes and provides an audio waveform
VCV	ADSR	Takes a Gate Input and provides and envelope for VCA MIX
VCV	VCA	Voltage Controlled Amplifier (volume) – Left Stereo Channel
VCV	VCA MIX	Four Channel Mixer with Volume Level Sliders controlled with voltage input from the ADSR
VCV	SCOPE	The SCOPE shows the signals from the 8VERT module being 180 degrees out of phase.
VCV	AUDIO	Interface to the speakers
VCV	MIDI -> CV	MIDI notes from a keyboard converted to a Control Voltage
VCV	WT LFO	Wave Table Low Frequency Oscillator. WT POS is set at 0% to produce a Sine Wave
VCV	VCA	Voltage Controlled Amplifier (volume) – Right Stereo Channel
VCV	NOTES	Information about the patch

Notes about the patch

Use the WT LFO Knob to control the speed of the panning (Ping Pong).

The WT LFO along with the 8VERT module create the Ping Pong effect. WT POS is set at 0% so that a sine wave is generated.

The WT VCO signal is sent to two inputs on 8VERT. When an 8VERT knob is hard right, 100% of the signal passes. When an 8VERT knob is hard left a -100% signal (i.e. inverted) signal passes. The VCA’s show the speed of the effect. The ADSR Envelope is triggered by the keyboard and fed to the VCA MIX.

The SCOPE shows the signals from the 8VERT module being 180 degrees out of phase.

Suggestions for Exploration

• Change WT LFO module’s FREQ and WT POS knobs. (hard right on both knobs create a bell like sound).
• Feed SEQ-3 Clock and Control Voltages into the WT LFO modules FM and POS connections.